SIEMENS SICAM A8000 INTEGRATION
SICAM A8000 integration for connected power systems.
SICAM A8000 configuration and integration using IEC 61850 and Modbus TCP, backed by recent project experience.
Discuss this application
Behnam’s recent SICAM A8000 work included IEC 61850 and Modbus TCP.
THE APPLICATION
Siemens SICAM A8000 integration
SQR Power Automation supports Siemens SICAM A8000 controller configuration and communications integration. Behnam Dizaji’s recent work with this platform included IEC 61850 and Modbus TCP. We bring that experience to projects that need electrical equipment data to reach the right control or monitoring system.
What we can deliver
- SICAM A8000 configuration and communication setup
- IEC 61850 and Modbus TCP interface integration
- Signal mapping, data checks and communication troubleshooting
- Commissioning support and agreed configuration documentation
HOW IT COMES TOGETHER
A clear route from device to system.
Define the signals
Establish which measurements, status points and supported commands the application needs.
Connect the interfaces
Configure the project-specific IEC 61850 and Modbus TCP roles and mappings.
Check the behaviour
Verify values, scaling, update behaviour and recovery when a device goes offline.
SEE THE TECHNOLOGY
SICAM A8000 — system overview
An official product video from Siemens Knowledge Hub. Product features vary by model and version; we define the integration around your equipment.
Visit the manufacturer’s product page ↗PLATFORMS & SCOPE
Built around
your equipment.
The integration starts with the actual controller, firmware, connected devices and required signals. We review data points, units, scaling and communication roles, then define how measurements, status and supported commands move between systems. Available functions depend on the installed hardware, software and protocol options.
BEFORE WE START
Can SICAM A8000 connect IEC 61850 and Modbus TCP equipment?
SICAM A8000 can support these interfaces with the appropriate configuration. We assess the device roles, supported data and point mapping for the specific project rather than assume every function transfers automatically between protocols.
Do you support projects across Ontario?
Yes. SQR is based in Waterloo and supports projects across Ontario. Site requirements, travel and the delivery schedule are agreed for each engagement.